MPFAN.PST Need Help

[speener]

We just purchased two Haas VF2 milling machines. I was able to get into the mpfan post and changed the mist to an air blast. I would also like to put in a home position to retract the Z all the way up and the Y all of the way out. When our programs have finished, the Z is at the retract amount and I manually retract the Z all the way up. I have to do the same to the Y also. Retract all the way out to take a look at the finished operation. I have no idea where to begin. I have changed code before in other post but can't seem to figure out what to do with this one. Any help would be greatly appreciated.

 

 

Thanks

Tom

[Radical1]

Hello Tom, the MPFAN post is somewhat of a tough post to work with, it may be easier to edit the MPMaster post that you can download from the emastercam website. The post is longer but all aspects of the post are there which makes it easier to edit.