AICC (G05.Q1) How to enable ?

[calver]

Mastercam X6 Mpmaster.pst the G05.Q1 property file, how to enable?

 

Control Panel : Fanuc Oi-MC

[AlbertZini]

In Misc. Integers

 

 

mr1 - High Speed

# 0 = Off

# 1 = Advanced Preview (look-ahead) control - G08 P1

# 2 = AI-NANO 2, AI(nano)CC output (Artificial Intelligence Contour Control) - G05.1 Q1

# 3 = AI-HPCC and AI-nanoHPCC (High Precision Contour Control) - G5 P10000

# 4 = Mazak Geometry Compensation/Accuracy G61.1, Mazak High Speed Machining Mode - G05 P2

#

# mr2 - Accel/Decel Value (for G05.1 Q1 and G61.1 only)

# 0 = No output

# Value = Accel/Decel coefficient

# Fanuc Notes

# 0 Least Accurate

# 10 Most Accurate

# R 0-3 Roughing

# R 4-7 Medium

# R 8-10 Fine

[calver]

Thank you very much AxelZu.

[SledGeek]

When I enable this on my Mpmaster (same controller) , it re issues a G49 and G5.1Q1 at each depth cut. The G49 sends the z back home on the second depth cut. How can I change it so it only posts both lines at the beginning of the op and not every z change ?

O0000.doc