8 replies to this topic

[hendri_yudianto]

why if do circle always any step in x+, x-, y+, y- axis..
so can't smoothest

[uncle_dolan]

what toolpath are you using? In contour ramp you can make sure 'linearize helixes' is unchecked to output G02 and G03 commands. Also can check your arc settings and machining tolerance

[hendri_yudianto]

circle toolpath in mastercamx3 tolerance 0.001 what any program in nc editor that correct. and not only do the circles, but sureface or solid same any step in x,y,z axis..

[Redfire427]

What freakin' language is this ?  I haven't even started drinking yet.

[Hardmill]

Redfire427, on 02 May 2012 - 07:05 PM, said:

What freakin' language is this ?  I haven't even started drinking yet.

hahahaha, it dont happen often but i bit my tongue and said nothin for a change.
Knew it was just a matter of time.

Dude we'd love to help you but we cant understand

IM GOING FOR A BEER











PEACE

[CADCAM3D5AXIS]

:cheers::cheers:

[Hockey Guy™]

Not sure on the language barrier either!

[K2csq7]

Backlash in your machine.

Machine 1 quadrant at a time, 4 toolpaths for 1 full arc. Use nice tangent lead in/out, adjust compensation for fine tuning at the machine.

[Rotary Ninja]

I think he is saying his arc moves are in small -x- and -y- increments instead of G02's and G03's. Would be my guess.