3 replies to this topic

[Jason @ CPM Industries]

Sorry found this topic

[Machineguy]

Jason,

This was covered not long ago for a Haas. Same type of problem. Tolerance / rounding error.
Do a search. I'll try and find it.

[Tom Matuszak from McCann Technical]

I am not sure as I have never seen that error but you might want to check your arc settings in the control definition. Helix support and Support arcs in XZ and YZ. Could be a place to start.
Tom

[JAMMAN]

I have seen that exact error, a few years ago posting an old anilam program to a haas. I had limited it to 3 decimal place output due to program size restrictions on the anilam. The haas was confused and gave that error. Added the 4th place and all was well.