X6 not posting can cycles (Lathe)

[KRICK]

Edited a what i tought was a good older post for for Lathe. Just changed the "Start of File & Toolchange Setup" to eliminate extra info at the begining of the program. The changes worked but after updating post i no longer get canned cycles to post,they are all long hand???? New to the post editing thing. (i put pack my changes and still no canned cycles)

[htm01]

rule #1.= always back up post before making changes.

[KRICK]

i did make a copy of the one that was working then altered the copy. When i reload the copy thats when i cant get any canned cycle to post. All i changed was the header at the beginning of the program.

[htm01]

do a file compare in cimco,something had to be changed..