Segment numbers in subprograms

[N.Paasivirta]

Hello, here's a little problem which is mostly esthetical - except for some Heidenhain controls, it isn't.

 

Obviously, when there's a subprogram, it's in the middle of everything and thus n$ number is whatever it happens to be at that moment. So when you merge the subprograms at peof$ postblock, you get this:

 

...

124 L Z+30. F MAX

125 TOOL CALL 0

126 M6

127 L M30

0 LBL 1 ; line number should be 128

1 L IY-21.65 R0 F MAX M99 ; 129 here, and so on

2 L IX-18.75 IY-10.826 R0 F MAX M99

...

 

So, in Heidenhain control, I'd like to get line (seqment) numbers to just keep counting after L M30.

 

 

I think there was some simple way to do this in a post, can't remember it...

 

(And yes, this is a post problem. I know about "Reset sequence numbers in subprograms" option in Control Definition. If it's not on the line number is just whatever it happens to be at the time the subprogram is created. In this case, 9, 10, 11 etc.)

[Grievous]

Do not worry about this.

 

When u will transfer the file in the controller all lines will be automatically renumbered by the controller.

[MikronGuy]

What Grievous said. Don't lose sleep over it.

The control will re-sequence the line #'s or you can do it manually in CimcoEdit before the transfer.