Rapid Rotary Position Moves??????

[slyym]

Is there a way to get Mastercam to properly show rotary axis position moves in backplot and verify from 1 operation to the next? In verify when A changes from one operation at A0. to the next operation at A180. it crashes thru the part. Its really bad in Multi axis paths. As far as I can remember it has always been that way. Not sure if its a problem or if that's just how it is.

[rrichard]

_{Well good luck for a response on this one, I've asked here and on the Mastercam site too and no one even says peep? I guess it's a stupid question, I don't know?}

[MIL-TFP-41]

 

 

Is there a way to get Mastercam to properly show rotary axis position moves in backplot and verify from 1 operation to the next?

 

AFAIK, the answer is no. And it sucks.

[Jayson Kramer]

All I can tell you is hold on as they know about this and are fixing it.

[rrichard]

Thanks Jay, that helps my confidence in  our program