default question

[cherokeechief79]

I use contour ramp a lot and sometimes I forget to uncheck the linearize helixes button.

how can I make it to be off by default?

this is in x6 but ill have to do it in x8 also.

thanks

mark

[vortx]

Sounds like you could use the defaults file (click - SAVE PARAMETERS TO DEFAULTS FILE). I'm pretty sure most every parameter of a toolpath operation is stored in the defaults file and then loaded when you create a new toolpath. Each subsequent toolpath then uses the settings of the previous toolpath but you can always click "LOAD PARAMETERS FROM DEFAULTS FILE".

[MadPickinSkills]

I just click the save parameters button

[cherokeechief79]

thank you!   I didn't know that!