5 AXIS HELP

[Dont]

I've been running and programming a HAAS UMC-750 for a year but only 3+2. I have first true 5 axis part and not sure where to start.  Any help would be appreciated not sure what path to use Thanks temp.mcx-8

[Gracjan aka Pullo]

All the grooves can be done 2+3 .+ transform

 

Gracjan

[Dont]

Even with cross section walls at 90 deg?

[Dont]

All the grooves can be done 2+3 .+ transform

 

Gracjan

Even with cross section walls at 90 deg?

[Dont]

I tried 5 axis curve but does not rotate about c to get the 90 deg web. It tilts B axis up and does a contour it needs to rotate in C axis but does not.

[crazy^millman]

Have you checked that your axis direction is correct? X Axis or Y axis or Z Axis?

[Dont]

Have you checked that your axis direction is correct? X Axis or Y axis or Z Axis?

Its set for Z axis

[Dont]

I've tried XYZ all do same thing

[CJep]

Is this whut you're lookin' for?

Curve multiaxis TAC - to a point (used the origin because it's the center of rotation)

Locked the output to 4 axis rotation around Mcam's Z axis

Used the surface for the tip control to set the depth.

I also rotated the part 90deg so the initial B output will be  0.0deg

 

 

 

[Dont]

Is this whut you're lookin' for?

Curve multiaxis TAC - to a point (used the origin because it's the center of rotation)

Locked the output to 4 axis rotation around Mcam's Z axis

Used the surface for the tip control to set the depth.

I also rotated the part 90deg so the initial B output will be  0.0deg

  Thanks but that's not area I'm having the issue its the through slots and not sure what tool path to use but I got the curve 5 axis TP to get close but doesnt rotate about C axis. 

[CJep]

Not certain what you're looking for, the description leaves a bit to be desired, here's a swarf tpath.

[Dont]

Not certain what you're looking for, the description leaves a bit to be desired, here's a swarf tpath.

Thats what I'm looking for thanks.