CIRCLE MILL CENTER START

[PcRobotic]

Hello everyone,

   I'm trying to control the CIRCLE function of ROUGHING.  I would like the TOOL to start at the center point of a circle and i tried to manipulate:

 

ROUGHING--------------- Check marked

    Step over amount: 5% of tool

 

     HELICAL - Check marked

           Minimum radius value: 5%

           Maximum radius value: 17%

 

However, it does not start at the center until I "0%" at "Maximum radius value".  I would like my "Maximum" keeping at the 17%

 

I also tried TRANSITIONS without enable FINISHING

   LEAD IN/OUT ---------- Check marked

          Entry/ Exit arc sweep value at 45 or 90

 

          START AT CENTER -------- Check marked

          OVERLAP  value .025

 

.................... And.... it is still not start from the CENTER of the circle, please help...., thank you for your help.

[crazy^millman]

This is not a posting question.

 

When you use start on center in the circle toolpaths that doesn't work? Got a sample file because I just did some RAH work with circle mill and it had to start on center to work correctly and like it has for years it did.