Active Reports: Capture Icon missing

[EMPIND]

Capture Icon missing:

 

The Camera icon, which I have seen in other posts, in the lower left corner of the Setup Sheet popup is missing in my window.

 

I would like to use the Capture feature; is there a setting I'm missing?

 

Thanks! 

[Mick from CNC Software Inc.]

Are you on a 4k monitor by chance? You should be able to see it as shown below.

 

 

Capture Icon missing:

 

The Camera icon, which I have seen in other posts, in the lower left corner of the Setup Sheet popup is missing in my window.

 

I would like to use the Capture feature; is there a setting I'm missing?

 

Thanks! 

[EMPIND]

Mr. George,

 

Thank you for your response; however, I figured out half of the problem.  Our shop uses MasterCam for SolidWorks 2017 and the Capture Icon is missing in that version. The Capture Icon is there when I loaded MasterCam 2017 stand-alone, which we do not often use.

 

Will the Capture Icon be added to the SolidWorks version of MasterCam?

 

Thank you,

EMPIND

[Mick from CNC Software Inc.]

I am not too familiar with McfSW so I will look into it and get back to you.

[EMPIND]

Thank you for all your help!

[Mick from CNC Software Inc.]

I got word from the developer that this functionality is currently under investigation due to the differences in graphics interaction between Mastercam and Mastercam for SolidWorks. I believe that there is a SolidWorks function under View:screen capture but I am not entirely sure if that is at all helpful.

[EMPIND]

Once again, thank you Mick.  I will see if that function is usable.

 

Regards,

EMPIND