HTML Setup Sheets - V9
----------------------

This product launches Internet Explorer 5.0 or above as a browser.

1. Run the .exe file to install to root directory of Mastercam drive
   (e.g. C:\Mcam9).

2. Change Mill9.cfg (Screen-Configure-Files) to use HTML.set as your
   Setup sheet template.  You may have to exit Mastercam after
   changing your default Setup sheet template.

3. Under Screen-Configure-NC Settings, change the Setup Sheet style
   to Post (uses .SET file).

4. Open HTML.set in a text editor and modify the Web Browser and
   Directory strings as necessary:

   sexplorer  "C:\Program Files\Internet Explorer\iexplore.exe"
   sdirpath   "C|/Mcam9/Mill/Setup/"

5. Images of your part can be obtained using a 'Screen Capture'
   utility or copied to the Clipboard with the 'WindowsKey+PrintScreen'
   keystroke, then pasted into the Paint application.  If a 
   file named <NCFilename>.gif exists in your NC directory, the
   image will be used in the Setup Sheet.  <NCFilename> represents
   the name of you posted NC file, without the file extension.

6. Limitations
   Directory and file names with spaces are not supported.
   Tested with IE 5.0 and above.
   Modify your post processor to include parameter information
   such as 'stock left' by modifying or adding these numbered 
   questions at the end of your pst file:

1501. Insert parameter information in the ascii NCI? n
1502. Write operation information to binary file (.ops)? y

6. Customization is available at an hourly development rate.
   Email posts@eMastercam.com to request customization.

--
mailto:posts@eMastercam.com
http://www.eMastercam.com