Mastercam 2020 lock on arc,point,ect

[Born to machine]

Hi,

in x9 you could get mastercam to lock on only arcs or points ect..see attached picture

In 2020 is this possible?

Thanks

 

[crazy^millman]

I have my RMB setup like this so I can do it through there.

 

[#Rekd™]

There is also the quick mask selections on the right side of the interface. These are quite handy for selecting types of geometry like points, surfaces etc. 
 

 

[Jayson Kramer]

At the top of 2020 graphics are is the Seletion bar. There is the drop down to pick say Arc Centers. Select it an on that same bar to the left you will see a lock. Select that to lock it.

[David Colin]

You also may activate hotkeys in autocursor settings then just press 'C' key to only select arc centers.

[gcode]

On 1/31/2020 at 7:21 PM, #Rekd™ said:

There is also the quick mask selections on the right side of the interface. These are quite handy for selecting types of geometry like points, surfaces etc. 
 

 

The bottom half of these circles mean "only" and selcting "arc only" works perfectly for selecting circles to drive drilling and circle toolpaths