Programming G112 by hand??

[Incogneeto]

Hi Guys, Anyone familiar with a Haas ST 30. Im trying to hand program axially a .25 hex X 1.25 long using the G112 with a 1/2 inch endmill and 3/8 material.

with a .010 radius at the points. Don't tell Daniel,But we haven't got Mastercam yet , and I'm trying to convince The Boss. I'm Not familiar with the G112 and its giving me Fits on the Radius.

Thanks for the Help.

[GoetzInd]

Just program it like you were milling in XY. Then double all your x values and change them to C.  I think.... Been 10 years or so.....

MIke  

[civiceg]

Haas uses Y instead of a C address like FANUC. Haas also uses staight xy code. You also do not have to double x values. 

What year st30? The NGC did have a software update to addrss alarms being generated with programs close to centerline. 

[Incogneeto]

2 hours ago, civiceg said:

Haas uses Y instead of a C address like FANUC. Haas also uses staight xy code. You also do not have to double x values. 

What year st30? The NGC did have a software update to addrss alarms being generated with programs close to centerline. 

EXACTLY !!! And I'm not sure if it can generate a .250 hex with an 1/2 Endmill. Adding the Radius to the offset it screams tool to Large.

And it throws alarms on The .010 radius.

I had no problems on the Okuma Captain But it was Years Back.

Would Love to understand how it works. I think its a 2012 But could be a Bit Newer Maybe up to 2016 I forgot to look, But will Monday.

Thanks for the Help Both of you.

[civiceg]

That should be no problem to do. I normally use wear comp, but you can use control or wear. Are you starting at the 3 O'clock position?  Shoot me you email and ill send you a sample nc file on monday. 

 

[Incogneeto]

15 hours ago, civiceg said:

That should be no problem to do. I normally use wear comp, but you can use control or wear. Are you starting at the 3 O'clock position?  Shoot me you email and ill send you a sample nc file on monday. 

 

I Did, Thanks Again.

[Incogneeto]

Did I Send The wrong E-mail?

[civiceg]

Just pm'd you

[Incogneeto]

12 hours ago, civiceg said:

Just pm'd you

Thanks so Much for your time. I'll give it a shot!!