Changing Direction on radial toolpath

[Doug Funny]

Greetings all,

I'm cutting a coin punch with serrations using a radial toolpath.  Is there a way I can change the direction the toolpath cuts? Its currently rotating around in a CCW direction and I want it to go CW.  Because the toolpath is rotating around CCW, its plunging down into the corner. I want it to ramp down into the corner so its not stressing the tool

 

Thanks,

Doug

[htm01]

are you cutting 0-360? if so make it 0-(-360)

[Doug Funny]

htm01, I've already tried that, no matter what I do it always rotates the toolpath in a CCW direction. I've tried a variety of values for this with the same result.

[htm01]

i tried it on plain radial, i see now you have high speed radial

[Doug Funny]

I was using the highspeed radial toolpath, I just tried the "standard" radial toolpath and I got it to go in the opposite direction