Okuma Schedule, Program Source alarm 2612?

[J Coulston]

Trying to get Okuma MB-5000 OSP-300 to run a schedule pallet program, one file on each pallet.
 

NSTRT
PSELECT TEST1.MIN
PSELECT TEST2.MIN
/GOTO NSTRT
END

Schedule works fine with two 1kb files, cycles thru with the pallet ready button until block skip is turned on. 

Schedule runs first 500kb program then alarms out when it should load the second 40kb program.  Both programs run file by themselves.

2612 Alarm-B Schedule program: main program load 5201 '1'

5201: Main program file was not found.

Assuming it is a memory limitation issue. The .MIN and .SDF files are stored in MD1:

How do I direct PSELECT where to load the files from?

TIA

John Coulston

[Greg Williams]

Try something like this,

N010 VSET V1=1
N020 PSELECT TETT-1.MIN
N030 PSELECT PART.MIN
N040 VSET V1=V1+1
N050 IF [V3 LE 10] N020
END

 

[Greg Williams]

You can also load subs

PSELECT LT300.MIN,OP1,MS759.SUB,Q1

and folders

PSELECT MD1:\TEST\NOEL.MIN

and drives

PSELECT HD0:\O6001.MIN

[YoDoug®]

That alarm is saying it can't find the file. It would be a different alarm if it were a memory issue. 

[J Coulston]

MD1:/ fixed it.

NSTRT
PSELECT MD1:/TEST1.MIN
PSELECT MD1:/TEST2.MIN
/GOTO NSTRT
END

Thanks all for your help.