Importing operation disables override arc feed rate

[Programinator]

So i exported a toolpath with the override arc feed rate checked.  When i imported it into a similar job that i was working on it imported with this option unchecked.  To me it should be imported checked.  right?  Anyone else see this happening?

[nperry]

On 6/24/2020 at 1:19 PM, Programinator said:

So i exported a toolpath with the override arc feed rate checked.  When i imported it into a similar job that i was working on it imported with this option unchecked.  To me it should be imported checked.  right?  Anyone else see this happening?

I haven't seen that but I have seen my "Override geometry diameter" box come in unchecked during an import. Not sure if it's supposed to happen but I learned the hard way that it does.

[Guest]

26 minutes ago, nperry said:

I haven't seen that but I have seen my "Override geometry diameter" box come in unchecked during an import. Not sure if it's supposed to happen but I learned the hard way that it does.

yeeeesh

[Programinator]

20 hours ago, nperry said:

I haven't seen that but I have seen my "Override geometry diameter" box come in unchecked during an import. Not sure if it's supposed to happen but I learned the hard way that it does.

WOW.  I have only seen the problem i originally posted on a contour toolpath.  Have not tested it on any other toolpath that supports override arc feed rate.  Can someone test it on a contour toolpath so i can see if its just me?