.mcam File drag & drop into mastercam GUI is not working Mastercam 2021 & Mastercam 2020

[@Mastercam]

is there any solution to fix it up. drag & drop of  .mcam file into mastercam GUI is not opening that file. 

issues with Mastercam 2020, Mastercam 2021

[Guest]

28 minutes ago, Dhananjay @Mastercam India said:

is there any solution to fix it up. drag & drop of  .mcam file into mastercam GUI is not opening that file. 

issues with Mastercam 2020, Mastercam 2021

Hi dl you have a dialog open lile a window from mastercam?

[@Mastercam]

14 minutes ago, byte me te smart doomb troll said:

Hi dl you have a dialog open File a window from mastercam?

kindly refer image 

[Guest]

4 minutes ago, Dhananjay @Mastercam India said:

kindly refer image 

Did you try restarting your pc?

[@Mastercam]

1 minute ago, byte me te smart doomb troll said:

Did you try restarting your pc?

Yes . still facing same issue. 

mastercam 2019,2018,2017 work properly

[Guest]

Are you using any 3rd party add-ins? Like a chook that has it's own window.

The only time I have seen that is when a window was blocking the main thread .

If you make a zip2go file and send it to [email protected] .

[@Mastercam]

52 minutes ago, byte me te smart doomb troll said:

Are you using any 3rd party add-ins? Like a chook that has it's own window.

The only time I have seen that is when a window was blocking the main thread .

If you make a zip2go file and send it to [email protected] .

No 3rd party application .

[Zaffin_D]

1 hour ago, Dhananjay @Mastercam India said:

No 3rd party application .

This can happen when Mastercam is run as Administrator.

[JoshC]

22 hours ago, Zaffin_D said:

This can happen when Mastercam is run as Administrator.

yea that is where i have seen the issue as well, right click on the mastercam.exe from its install directory and see if "run as administrator" is checked and check the shortcut that you are using to start mastercam with as well 

[@Mastercam]

On 7/4/2020 at 10:54 PM, Zaffin_D said:

This can happen when Mastercam is run as Administrator.

Thank You ! it works well.