5 axis post change depending on trunnion position

[KORLOY]

Hello guys!

We bought new Okuma mu4000v and I need to make some  changes in my postprocessor. I have post for our  mu5000v which works fine and I want to set up this post for new machine.  Main differences of those machines is trunnion position according to XY axis. I'm adding some photos to make it clear.

Is there enough to change only vector section of the post (added the photo) or is there something else? 

 

 

For MU5000v vector section in the post looks like this:

Thank you for the answers guys!!

 

 

[Leon82]

Can you just copy the machine definition and change it in the machine def?

[crazy^millman]

That looks like MPGEN5AX and don’t think that is connected to the machine definition. Need to get a hold of your dealer and get the PDF for that post it has a lot of good information on what you need to do. 

[Greg Williams]

That one is not connected to the machine and control def. You can change the settings around to run a BC output, Are you running G169 and CALL OO88 from that post? If yes you may need to do some work in there as well if you are running a 3+2 safe approach for 5 axis

 

N1 T6 ( EMUGE 12250A   TOOL - 6 )
M6
G15 H1
G0 G90 A-63.1049 C19.1142 S4000 M3
CALL OO88  PX=0. PY=0. PZ=0. PC=19.1142 PA=-63.1049 PH=1 PP=51
G0 X3.5817 Y28.2171
G56 HA Z101.0398
G15 H1
M510 (CAS OFF)
G169 HA
G1 X-30.3024 Y98.3763 Z20.5411 A-63.1049 C19.1142 F15000.
G131 J2 E=0.05 D=0.025 I0 F25000. (SUPER NURBS ROUGHING)
M8

[KORLOY]

On 8/2/2020 at 4:13 AM, Greg Williams said:

That one is not connected to the machine and control def. You can change the settings around to run a BC output, Are you running G169 and CALL OO88 from that post? If yes you may need to do some work in there as well if you are running a 3+2 safe approach for 5 axis

 

N1 T6 ( EMUGE 12250A   TOOL - 6 )
M6
G15 H1
G0 G90 A-63.1049 C19.1142 S4000 M3
CALL OO88  PX=0. PY=0. PZ=0. PC=19.1142 PA=-63.1049 PH=1 PP=51
G0 X3.5817 Y28.2171
G56 HA Z101.0398
G15 H1
M510 (CAS OFF)
G169 HA
G1 X-30.3024 Y98.3763 Z20.5411 A-63.1049 C19.1142 F15000.
G131 J2 E=0.05 D=0.025 I0 F25000. (SUPER NURBS ROUGHING)
M8

Hi guys!

Yes I'm running CALL OO88 from the post and it works fine for 3+2 applications (there is no need for G169/TCPC at the moment). And I'm wondering what changes to do in the post to make it work for the new machine. I have open post from HAAS UMC 750 - I will try to copy some logic from that post. Is there enough to change post in the vector section or I have to change something in the machine definition manager?

Thank You for the answers guys!

Best regards!