hybride toolpath skipping around

[HEAVY METAL]

CH002499r2.tifCH002499r2.tif

If you look at the  hybrid  tool path it is not going all the way down from the top to the bottom . At some point om the way down it jumps down to about the top of the fillet in the bottom . then goes back where it left off and finishes .  Nothing gouge but you can see the squiggly line that takes off about in the middle and starts somewhere else .  I don'y know  if there is a problem with the model but I have tried missing with different settings in the toolpath but know luck.  I tried both machine as solid and surface and same thing. Any ideas whats causing this .

 

Thanks 

[crazy^millman]

Might try blend on that shape grabbing the upper and lower edges. I would go to my favorite Morph toolpath from what I can see in that picture. Have you tried waterline?

[JoshC]

sounds like the limiting angle is causing the path the jump around a bit, you can change the limiting angle or better yet for that feature your trying to cut in that image i would think waterline would do a better job. i would just change it from hybrid to waterline and call it a day, waterline will probably do that perfectly since its pretty steep faces.