Tool Change Help

[Im Old Gregg]

I just want to apologize in advance if this comes off as dumb but I have been looking everywhere to try and solve my problem. I recently started to use a Haas 3axis mill/ Acu-Rite controller with mastercam2020, The problem i'm having is I do not have a tool changer for this mill so when I go to load my file it tells me "mount of tool has failed". Is there a way to manually install the tool by hand and just skip the tool change part within the code? Any help would be greatly appreciated.

[Matthew Hajicek - Singularity]

Haas machines come with Haas controls, not Accu-Rite controls.  If you have a retrofit I'm afraid no one else is likely to have experience on the same machine, and you should contact Accu-Rite.

[Leon82]

Delete the tool change from the program first. If it works without error then you have a starting point

[Im Old Gregg]

18 hours ago, Leon82 said:

Delete the tool change from the program first. If it works without error then you have a starting point

I've been looking everywhere within the program and cannot find an option to delete a tool change unless you're referring to removing the line in G-code.

[Leon82]

2 hours ago, Im Old Gregg said:

I've been looking everywhere within the program and cannot find an option to delete a tool change unless you're referring to removing the line in G-code.

Yes remove the g-code first and see if it works