3d parallel

[tazbierek]

Hi guys, i need to use paralelle on this project 

 

It looks ok but i need to put start point away from my solid, also i needput some additional offset from center of my tool , but whatever i use ( inside outside or center)

the results are the same as shown on screen, can u help me ?

 

And hope u know what i mean 

 

 

i see that 

 

There is (o) in conpeinment .

Also i need to change lead in and lead out for the material /

I see no option in surface finish parallel. 

 

 

[tazbierek]

Ok now i have this 

 

I set Containment, so now i understand that offset tool which is not bad in my opinion,

 

Still dont know how to set lead in and lead out, startting point looks like doesnt work 

[Rstewart]

If you have a file to share, I can help you out when I get to work tomorrow.

There's Lots of different ways to control that path including extending surfaces, direction, start point, and lead-in / lead-out arcs.  

[tazbierek]

It can be any finish model. i just cant see where i can set lea in and out in finish parallel. 

Can u explain me where?

[#Rekd™]

Post your valid Mastercam file and someone will help you.