Post debugger in 2021

[So not a Guru]

Is this no longer supported? It is not listed in the Advanced Configuration utility.

NM,I guess I should read the documentation before posting.

[JParis]

Enabling the Post Debugger

By default, access to the Post Debugger is turned off. To enable this feature, complete the following procedure: Start Mastercam 2021. Select File, Configuration to open the System Configuration dialog box. Select the Post Dialog Defaults page. Select Enable post debugger. The Post debugger ...

General/Enabling_the_Post_Debugger.htm

Don't forget that after a config change to restart Mastercam

[ChrisVermaak]

Any guide on how to start this post debugger, or to use it. I have MC2023 and need to modify the post.

Actually an old post I have always used on my Haas VF3 but now that post won't output decimal points on drill sizes in the tool table (at start of NC file)