Select single edge?

[kunfuzed]

I went from X9 to 2021.  How do I select a single solid edge for say a contour?  Right now under "Selection Method" I use "Edges", but then I have to hit the "Previous" button under "Branches" to get down to the single contour I want. 

 

[JParis]

Here's a tip...

When you're in a full chain and you only want a part of the chain.....click the chain(it will close the loop) then select that past piece of the chain you actually want(it will revert to partial)

[Aaron Eberhard]

The easiest way is to turn off "face" mode and just use "edges":

If you want the convenience of both on, then just be a bit more careful about where you click.

Clicking with your mouse over the face like this will select all 4 edges of that face (Face mode).

Clicking when your mouse is over only this highlighted edge will select only this one single edge.

[JoshC]

its the Cplane vs 3d setting in the solid chaining manager, change it to 3d and it will select just the single edge, see gif below. 

[kunfuzed]

5 minutes ago, JoshC said:

its the Cplane vs 3d setting in the solid chaining manager, change it to 3d and it will select just the single edge, see gif below. (gif is loading ill revise this posting once its done)

Hot Damn!  That's just what I was looking for!

And thanks for the other tips guys!