Change Post Output to Remvoe X-axis Homing

[JamesOttawa]

Hi everyone,

 

I want to change my post output to make it so that at the end of my post I get G28 Y0. A0. instead of G28 X0. Y0. A0.

Essentially I want to remove the X homing cause it puts my Hass TM-2 table in an awkward spot.

Normally I change this in the post editor every time but it would be nice if it could do it automatically.

 

Thanks alot,

Cheers.

 

[crazy^millman]

12 minutes ago, JamesOttawa said:

Hi everyone,

 

I want to change my post output to make it so that at the end of my post I get G28 Y0. A0. instead of G28 X0. Y0. A0.

Essentially I want to remove the X homing cause it puts my Hass TM-2 table in an awkward spot.

Normally I change this in the post editor every time but it would be nice if it could do it automatically.

 

Thanks alot,

Cheers.

 

Reach out to your dealer or put up a Z2G with your post you are using in that and then someone can help point you in the right direction.

[Rstewart]

This has been discussed a ton of times.  You can find your answer using the search function.