Transform Logo???

[Rob B]

Is there a way to transform my logo into a 3d solid that i can 3d print? See attached file.

[Guest]

1 minute ago, Rob B said:

Is there a way to transform my logo into a 3d solid that i can 3d print? See attached file.

Rast2vec chook will get you the wireframe in mastercam, from there you could solid extrude, you would have to clean up the wireframe a bit

[Rob B]

I tried raster to vector. I didn't have much look getting the full detail that I wanted. I don't know a lot about raster to vector.

[Guest]

9 minutes ago, Rob B said:

I tried raster to vector. I didn't have much look getting the full detail that I wanted. I don't know a lot about raster to vector.

Try filling in the solid color areas with white perhaps.

I think there is some tweaking in the settings also

Im on my phone so I cant check

[#Rekd™]

If raster to vector doesn’t work try Inkscape. It is a free software similar to Adobe Illustrator. Make sure the photo file is high resolution, if it isn’t the results might not be great.

watch this video.

Once you get a dxf you will need to make it into a solid.