Simplifing models

[cncasylum]

Hello everyone hope all is well,

            I'm not sure what to do with the section of the model that doesn't have curves for fillets and faces. I'm on a 5 axis Mu5000v ( big time rookie...its cool though ) I think I want to get the 2 faces with a parallel toolpath id like to run normal to both surfaces and walk up rad on second face.  

                                                                                                                                                                                       Thanks for your time in advance

14713.emcam

[cncasylum]

Hay guys I'm laughing ,  

               I was reading past content I had created and found advice pertaining to all wireframe getting copied to new level. BINGO.. From there a simple 2d fillet. Sometimes overthinking can be an enemy (for myself any who)