Swarf Machining stuttering on C-axis

[crazy^millman]

12 hours ago, Metallic said:

Thanks I will try this out when I get back into the shop. Would be nice to have both MachSim and Vericut.

 

Is it true that MachSim can now verify posted Gcode? I can't remember exactly where I recently saw a video that said you can simulate posted code within Mastercam.

EDIT: I believe it was some recent webinar..maybe ShopWare or someone else went through it

It is tied to a Post it reading the mi and mr vales to help, but I am not aware of NC code Verification at this point. They have no control emulator built so until that happens they will never be able to emulate what other true CAV software are doing that have control emulators that take machine parameters and use them to simulate not only kinematics, but macros, variables and other things Machinesim is not currently able to handle or support. Again this is my understanding of where thing are and I can be wrong.

[Metallic]

On 6/5/2021 at 10:43 AM, crazy^millman said:

It is tied to a Post it reading the mi and mr vales to help, but I am not aware of NC code Verification at this point. They have no control emulator built so until that happens they will never be able to emulate what other true CAV software are doing that have control emulators that take machine parameters and use them to simulate not only kinematics, but macros, variables and other things Machinesim is not currently able to handle or support. Again this is my understanding of where thing are and I can be wrong.

That makes sense Ron, until if/when it becomes full on CAV I will continue trusting Vericut.