Lathe Canned Rough

[Joe777]

prcc_call_end$

almost works as intended, besides other redundancy, it completely ignores subout$ in plin0$.

"G0 Z.0707
G0 Z.11
M9
M205
G91 G0 G28 X0.
G28 Z0.
G90"

Should be one the lower turret, yet somehow it ends up being written to a wrong channel.

 

(****************************************************************)
(*********************** UPPER TURRET TOOLS *********************)
(****************************************************************)
(****************************************************************)
M200 M300
G0 G18 G20 G69 G80 G40 G90 G94

G109 L1 (UPPER TURRET)
G91 G0 G28 X0 Y0
G28 Z0
G90 G53 B0

G0 Z.0707
G0 Z.11
M9
M205
G91 G0 G28 X0.
G28 Z0.
G90

M30

(****************************************************************)
(*********************** LOWER TURRET TOOLS *********************)
(****************************************************************)
(T3  | ID ROUGH R0.0313)
(****************************************************************)
G109 L2 (LOWER  TURRET)
G91 G0 G28 X0
G28 Z0
G90

(T3  | ID ROUGH R0.0313)
N3 ( OP NO.3 )
G10.9 X1
M901
M202
T003003
G90 G54
M8
G0 Z.11
X4.6633
G18
G92 S6000 R2
G96 S100 P1 M203 R2
G0 Z.0707
G95 F.01
G271 C.1 R0.
G271 P100 Q110 U-.02 W.01 F.01 S100
N100 G0 X5.4958 S100
G1 Z.0524
X5.3137 Z-.0387
G3 X5.2954 Z-.0608 I.0221 K-.0221
G1 Z-.1251
X4.7849
G3 X4.7407 Z-.1342 K-.0313
G1 X4.6999 Z-.1546
N110 X4.6633
M30