morph tool path

[keepinupDC]

Hello all, I have a need to extend surfaces / tool path to compensate for some machine backlash I have in a custom machine tool. Similar to how flowline toolpath using gap settings Tangential line length.  

Right now I use morph tool path and i'm not familiar with this path whatsoever, just learning it now.  

Thank you all and have a great weekend. 

[#Rekd™]

Post a valid Mastercam file. 

[keepinupDC]

@#Rekd™

I have everything in this file set up exactly how I need it, just need to extend the cuts to compensate for backlash. 

Thanks for your time. 

Ash Single Morph 9-10-21.mcam

[#Rekd™]

I had a quick look at it, looks like you would need to build new surfaces to extend them. Hopefully someone else with more experience will look at it as they might have a better solution.

This should be posted in the Industrial Forum.

[keepinupDC]

@#Rekd™

Thanks for taking the time to look at it, I was getting afraid of this but it's doable just a little more time invested. 

[crazy^millman]

There are extend features in that toolpath. Use them and no extra geometry needed.