problem with multiaxis parallel toolpath

[aaron tabor]

I'm following a multiaxis tutorial book and I've come to a point where this toolpath instead of staying within the boundaries or retracting to the clearance area its cutting through the wall.  The toolpath I am referring to is number 6.

TUTORIAL 2 SWARF with toolpaths.ZIP

[JParis]

Sight unseen, in that suite of toolpaths, check your Collision Control.....you may need to add some faces and use a Retract Tool option..

Might be a top surfaces or a side surfaces depending on the geometry

[crazy^millman]

19 minutes ago, aaron tabor said:

I'm following a multiaxis tutorial book and I've come to a point where this toolpath instead of staying within the boundaries or retracting to the clearance area its 

Well you have no corner radius on the tool I defined it correctly and got good motion.

[aaron tabor]

36 minutes ago, JParis said:

Sight unseen, in that suite of toolpaths, check your Collision Control.....you may need to add some faces and use a Retract Tool option..

Might be a top surfaces or a side surfaces depending on the geometry

I added a retract option in collision control and it stopped cutting through the walls so you were right, thanks.