Camplete Truepath G18/G19

[jerms]

Good morning all.

I recently started with a new company that uses Camplete. So far its not a bad transition. However, I am having problems with a flowline toolpath that is outputting point to point rather than simple arcs. I reached out to the reseller and was told it doesn't support arcs in plane outside of G17?  I'm not sure if the reseller doesn't support this or if Camplete doesn't.    

Can anyone confirm this?  

 

Thanks!

[crazy^millman]

4 hours ago, jerms said:

Good morning all.

I recently started with a new company that uses Camplete. So far its not a bad transition. However, I am having problems with a flowline toolpath that is outputting point to point rather than simple arcs. I reached out to the reseller and was told it doesn't support arcs in plane outside of G17?  I'm not sure if the reseller doesn't support this or if Camplete doesn't.    

Can anyone confirm this?  

 

Thanks!

It can support it. Get a hold of IVAN at CAMPLETE and he will help you get it sorted out.

[Leon82]

there are a few arc settings in the advanced tab. i haven't really looked but i believe it supports those arcs. 

[cncappsjames]

Go to the Manage tab. Click on Options in the Tools ribbon. Click the Advanced button on the left. Click OK wieh you see the prompt. In the Find Preference field type "Convert Helix" then click click the Find Next Button. In the lower part of the dialog box you'll see a check box. Uncheck that. Click Close. Close CAMplete. Reload your project. You should see more arcs and less point to point motion.