problem with 4 axis tutorialc(RESOLVED)

[aaron tabor]

I'm doing a caminstructor 4-axis tutorial I get to a point where I am supposed to drill a hole at an angle, I use axis substitution and set everything right as far as I can tell but instead of drilling straight into the hole its coming from the right at like 45 degrees I added a link so you can see the file.(file was too big to upload so i used dropbox)

https://www.dropbox.com/s/i2yvacw3rejipne/4%20axis%20tutorial%201%20with%20toolpaths%20solid.emcam?dl=0

[#Rekd™]

Change the Rotary Axis settings as per the photo. There is no geometry to unroll or roll. 

 

[aaron tabor]

2 minutes ago, #Rekd™ said:

Change the Rotary Axis settings as per the photo. There is no geometry to unroll or roll. 

 

That worked thanks