Arc AND point

[JFK_LC_MFG]

Not sure what I did, but I've recently switched computers and all of a sudden when I create a Center Point Arc, MasterCAM is now actually creating a point at the center of the arc instead of just the arc. Could anyone point me in the direction of how to change this back? Any help would be greatly appreciated. 

Thanks!!!

Jon

[gcode]

It's a setting in System Config.

You can turn it off or on. I'm not at my computer right now and don't remember where it is

[David Colin]

Uncheck this on Home tab

[JParis]

31 minutes ago, JFK_LC_MFG said:

Not sure what I did, but I've recently switched computers and all of a sudden when I create a Center Point Arc, MasterCAM is now actually creating a point at the center of the arc instead of just the arc. Could anyone point me in the direction of how to change this back? Any help would be greatly appreciated. 

Thanks!!!

Jon

On the Home Tab....center top...Arc Center Points...

You may need to click that to turn it off

[JFK_LC_MFG]

Thanks for the reply David, but I already have that setting turned off. I believe that refers to the graphical point in the center of an arc. Somehow mine is actually creating a "Point" just like you would with Point Position at the center of the arc.

[David Colin]

Then it's in system config. Select 'none' in CAD settings