New turning tool and not sure how to program for it

[CNCZACK]

Just received a new turning tool 

https://www.ingersoll-imc.com/product-family/4092566?quick-search=supert 

 

anyone ever programmed for these style of tools? what did you have the most success with? Were going to test this out at some point today. Not sure if a Dynamic toolpath is best or to try and lie to it and try to "coroturn"

[gcode]

It looks like Ingersoll is imitating Sandvik's Prime line of tooling

You are going to have the build a custom tool which will be difficult as there doesn't seem to be any models available for download yet

Once you have your custom tools defined the regular turning and facing toolpaths should work

For roughing I'd try Mastercam's Prime module

The Product Bulletin at the link has a lot of info.

After flipping through it, these tools may be a direct replacement for Sandvik Prime tools

It's been about 7 years since Prime came out, maybe their patent has expired ??

[JB7280]

8 hours ago, gcode said:

It looks like Ingersoll is imitating Sandvik's Prime line of tooling

You are going to have the build a custom tool which will be difficult as there don't seem to be any models available for download yet

Once you have your custom tools defined the regular turning and facing toolpaths should work

For roughing I'd try Mastercam's Prime module

The Product Bulletin at the link has a lot of info.

After flipping through it, these tools may be a direct replacement for Sandvik Prime tools

It's been about 7 years since Prime came out, maybe their patent has expired ??

Ingersoll isn't always great about putting their models on the website.  I'd ask your rep, or check MachiningCloud.