Looking for post for a Mori Seiki Horizontal mill with a MSX-701IV control

[Tim Scheuerlein]

We had a programmer leave and lost our post and machine definition for our Mori Seiki NH 5000 Horizontal mill what we have is faulting out when we go to post and it isn't putting in our B axis in correctly can anyone help 

[JParis]

Reseller or Official forum

https://forum.mastercam.com/

Downloads there..you will need to link your account if it's not already done..

BTW, you may have a copy of the necessary files if someone made a z2g file at some point...

Otherwise...backups??  

Which then leads to, are you sure the file is set up to post properly...

[gcode]

I once knew a shop that was too cheap to buy a decent PC so the programmer, (Me) bought a powerful laptop and used that.

When I left they were screwed.... I did leave them working copies of their posts though  

[Chris In-House Solutions]

If you purchased the post the company that wrote the post should have a backup copy of the post.  If you know who your purchased the post from you should be able to reach out and get your copy back.  

You could try mpmaster there is a HMC machine def included in the files.  If you try that post WCS should equal TOP and tool/Cplane would be FRONT, RIGHT, BACK or LEFT for the primary planes.