Trouble with Toolpath Transform

[JParis]

Interesting...nope it's not..

I do see a usage of transform that I have never done before...I don't knoiw if it's related to that or what.  It's not a post issue and the basic MPFAN does the same... 

I tried a couple different things and still see the same issue....it makes me wonder if it isn't the file itself.

That's a good one for QC

[Rstewart]

10 minutes ago, JParis said:

Interesting...nope it's not..

I do see a usage of transform that I have never done before...I don't knoiw if it's related to that or what.  It's not a post issue and the basic MPFAN does the same... 

I tried a couple different things and still see the same issue....it makes me wonder if it isn't the file itself.

That's a good one for QC

Thanks for checking it out.  Btw, it also does this behavior on two other toolpaths.  What is my usage of transform that you've never seen before?

[JParis]

1 minute ago, Rstewart said:

What is my usage of transform that you've never seen before?

When I have different planes, I use the Plane option...also the Delta setting,I have only used that in a single plain setting..

I will say, I wonder if the fact that both offsets share the same XY location is a factor in what's happening

[Rstewart]

This *Should* be Very common, how else would you tackle multiple parts in a VMC?  Two vises, two parts.  

I'll get this sent off to QC at mastercam

[JParis]

4 minutes ago, Rstewart said:

how else would you tackle multiple parts in a VMC? 

I would program them side by side

[JParis]

I found it....

Go into your Misc Ints...#1 is set to 0....

Change it to 2 and it posts as you would expect

JP_PIF35232_03.mcam

[Rstewart]

20 minutes ago, JParis said:

I found it....

Go into your Misc Ints...#1 is set to 0....

Change it to 2 and it posts as you would expect

JP_PIF35232_03.mcam 3.4 MB · 0 downloads

I knew there was something I was missing.  Thanks again man

[JParis]

1 minute ago, Rstewart said:

Thanks again man

You're welcome!