Radius part with C axis?

[CNCZACK]

Im not sure what I can use on this part to create the .36 radius with a C-AXIS vtl. When doing these on a mill i create a drive surface and use flowline and can get it done. I tried the same but I dont think flowline supports c-axis. I tried messing with opti rough a little but im not sure where to go or what the correct path would be to use on this. I do not have a multi-axis license. 

 

any suggestions? 

 

 

RAD.mcam

[GoetzInd]

*IF* you're post is set up right, I think all 2d/3d toolpaths can support C-axis. Go to the axis sub tab and select 3 axis.

 

Mike