Anyone seen this error when running verify in 2022?

[Müřlıń®]

[Müřlıń®]

it seems to be the same no matter what machine I choose.

It appears to be non fatal and the post outputs the correct code and If I do nothing with the popups I can run verify just fine.

Then when I close out the popups it gives exception error.

Sometimes it will go away for a session but comes back.

I have tried it with inhouse, Postability and generic  5 axis defs and posts.

 

 

[Müřlıń®]

ok guys Ben was having the same problem and by chance he just figured it out today.

I have never had to set a machine in verify before all these years...

but I had to select a 5 axis machine on the simulation tab in the verify page...

 

 

[CEMENTHEAD]

18 hours ago, Müřlıń® said:

select a 5 axis machine on the simulation tab in the verify page...

Can confirm. not always but this does pop up occasionally. Should be an empty place to select nothing for simulation. one of my guys spent hours trying to figure it out before he asked the question. 5 axis pgm he was set at 3axis in simulation. We use vericut. (facepalm)