MCAMX9 MPHUR.PST needed for Hurco VM1

[Simpleman67]

My computer hard drive crashed and I need the MPHUR.PST files for a Hurco VM1 . I have contacted my dealer here in NC {BarefootCNC} and they sent me the Hurco_VM2 post files . I entered everything and when I go to run the program I get an error message : ARC RADIUS OUT OF TOLERANCE . I can take the same NC file over to the Hurco VM2 and it runs fine . My previous post before hard drive failure was MPHUR.PST  and it worked well for both . I have worked back and forth with Barefoot sending files etc and I have yet to get it to run a program .Does anyone know where I can get the MPHUR.PST post files ? It will greatly be appreciated !!! 

Thanks , Kevin

[TFarrell9]

I don't have those post files, but did you check your wear comp on the first machine that gave you that alarm? It sounds like a fanuc alarm where the wear comp value is too great for the radius to be cut. Another one is where G41/G42 are on the same block as G2/G3, but I believe the alarm wording is different than that.

[gcode]

I would experiment with the arc settings in the control definition 

[Simpleman67]

Thanks for the response ! Barefoot kept at it until they got me the HUCO_3AXIS  control file and the MPHUR.PST file and it took care of the arc errors . 

[crazy^millman]

2 hours ago, Simpleman67 said:

Thanks for the response ! Barefoot kept at it until they got me the HUCO_3AXIS  control file and the MPHUR.PST file and it took care of the arc errors . 

As I knew they would.

Jimmy, Katie, Jamie, Jason and the whole crew are top notch in my book!!!!