Mastercam 2023

[GARRJESS]

I just switched over to Mastercam 2023 a few weeks back and while creating a new plane for some 5 axis programming I noticed something different. Not sure if this was intentional or a glitch. I created a new plane in the planes manager I named it and set my X & Y & Z origins as zero like I always do and set my work offset to zero. 

I'm using a file from 2022 because the part I'm machining is almost identical to the new 1 so I have very little to change. Hence the new tool plane. When I switch the toolpath to the new tool plane it says the origin is X0. & X0. & Z0. But if you look at the attached pictures in the planes manger the new side 1 is showing a different set of values even though I made them all zero's.

Can any body explain.

Regards

garrjess

[Leon82]

when you have duplicate planes the t/c will jump back to the first one when you change the views. this has been like that for a while

[GARRJESS]

Here's the problem its only duplicate by name , its a totally new plane. Different  angles. Plane 1 is 87.7663 degrees and new plane 1 is 86.0336 degrees.