Turning front and back of part maintaining Zero point without using Stock flip option.

[ROBERT III]

Im currently using stock flip to achieve this.

My issue is, it seems to interfere with the creation of a stock model to use for mill ops.

Due to Covid my lathe training was canceled.

I know there has to be a way...lol

VAC FITTING.mcam

[CNCZACK]

On 2/3/2023 at 1:53 PM, ROBERT III said:

Im currently using stock flip to achieve this.

My issue is, it seems to interfere with the creation of a stock model to use for mill ops.

Due to Covid my lathe training was canceled.

I know there has to be a way...lol

VAC FITTING.mcam 1020.8 kB · 7 downloads

Something like this? i am using stock flip but did notice it was flipping to the other side. i see a lot of weird toolpaths in this. i adjusted a few just messing around with it a bit 

VAC FITTING.mcam

[crazy^millman]

On 2/3/2023 at 10:53 AM, ROBERT III said:

Im currently using stock flip to achieve this.

My issue is, it seems to interfere with the creation of a stock model to use for mill ops.

Due to Covid my lathe training was canceled.

I know there has to be a way...lol

VAC FITTING.mcam 1020.8 kB · 8 downloads

What stock model? Cannot throw up something that is not complete then say there is a problem with a process that is not showing the problem you are having. Please provide a file with the stock model issue you are having then someone can see exactly what you are seeing.