pencil pass problems

[bhayden10]

I am hoping someone will help me out here. I put a file in the x3 folder called pencil pass. I programed this in X and I only have x3 on my computer now and was wanting to try to change this pencil path and when i regenerate the operation (#34) The tool will only cut one side of my part when it used to cut both sides the same way. I would also like to keep the tool down more and not veer over to where the red surface is on entry if possible. I appreciate any help offered as this type of pass won't play nice with me.

Thanks

[cobra95kev]

Brian,

I wasn't able to use the existing operation to get a good result but I did add a new one and it looks better using HST Pencil toolpath. I couldn't get it posted to the FTP but if you send an E-mail to me at [email protected] I will send it to you.