Listing tools in the header

[George Gerhard]

Hello everyone

I would like to list in the beginning of the program all the tools numbers, the descriptions, and the offset used.

What words am I needing to capture to display this.

many thanks

George

[iowajim62]

If your using MPMaster post, there is a switch for tool table in General Output Settings you can use. Default is a 0, changing this to 1 will put a tool list at the top of your posted program.

[George Gerhard]

not using mpmaster, but that should give me the guidance I need

thank you

George

[Btetrick59]

Good morning all I have a simple question about changing a post to add a tool list to the header of my programs,

The rep was by last week and helped the mill guy's with a problem and did this for the mill post. So of course I needed it for the Lathes x14

Found the part in gen setting to change this but changing it made things worse

of course I did not change the oring.post so back to it I went.

Is there a easy # change or do I need to get the book.

Thanks Brad