mill

[Joels]

Hello, I am trying to simulate a mill machining operation in Mastercam X4. The stock is a round bar of 1.25 diameter. I want the bottom of the bar to be Z zero so that is how the model is on the screen. I set up the stock the same way so they are on top of each other. The problem is when i run the verify the stock drops down so the center of the bar is on Z zero instead of the bottom of the bar. How do i get this to stop?

[Span]

In verify options click use stock setup values under boundaries.

[Joels]

Span,

Thank you. I had to uncheck "center on axis" and it worked fine.