V9 mpmaster help (HAAS IJK & Q)

[McLaren]

Hi guys, I need some help getting mpmaster (V9) to post out both ijk style peck drilling, as well as q style. Q's come out fine before IJK calls, but after IJK calls they end up being just I's. I am pretty sure it has something to do with switching the addresses back but I couldn't get it right.

Here's what I have so far;

ppeck           #Canned Peck Drill Cycle
     pdrlcommonb
     pcan1, pbld, n, *sgdrlref, *sgdrill, prdrlout, pdrlxy, pfzout, pcout, 
       *peck1, *feed, strcantext, e  
     pcom_movea

pmisc2          #Canned Misc #2 Cycle (HAAS DRILL WITH IJK)
     pdrlcommonb
       result = nwadrs(stri,peck1)
       result = nwadrs(strj,peck2)
       result = nwadrs(strk,peckclr)
     pcan1, pbld, n, *sgdrlref, *sgdrill, prdrlout, pdrlxy, pfzout, pcout, 
       *peck1, *peck2, *peckclr, *feed, strcantext, e  
     pcom_movea

 

Thanks in advance for any and all replies.

[McLaren]

I think I got it. I added in:

#Address string definitions
strq	    "Q"

 

and changed ppeck to this:

ppeck           #Canned Peck Drill Cycle
     pdrlcommonb
     result = nwadrs(strq,peck1)
     pcan1, pbld, n, *sgdrlref, *sgdrill, prdrlout, pdrlxy, pfzout, pcout, 
       *peck1, *feed, strcantext, e  
     pcom_movea

[poi8848328]

Hello, according to your settings, my post-processing did not realize the drilling IJK output, but it did not report an error.