Okuma Lathe OSP 100 UL Code Help

[Nathan G. Baldwin]

I'm having issues getting a program working that uses a turret, then b turret, which I thought was solely controlled by G13/14, however, when I load the program, It seems to want to run both at the same time, which gives me errors.. Further, because of this issue, i tried writing a scheduled program to run the two ops separately, which seems to be missing all but the M30 when I load it to run. Anybody deal with this often enough to help?.

 

 

attached file is the one i'm working on. it's a combination of another programmer's original and my addition of the drill/tap cycle at the end (all done by the B turret)

[YoDoug®]

You need to use wait codes or both turrets will run at the same time. Use P-99 in each stream of code to restart wait code count. Then P1, P2, etc. Wait codes must match in upper and lower. Meaning if you have a P1 in the upper but not the lower it will alarm.