Live tooling issue in Verify

[JACK2ME]

I've noticed an issue with verify and live tooling on the sub spindle. I'm drilling some face holes and the first hole is fine but after that the tool wants to come thru the back of the part. If I make separate operations for each hole then all is good. I've been told this is a plane issue. Does anyone know when this issue may get fixed? It was never a problem with previous versions.

[Reece L Gibson]

Might submit a file if possible I have seen this before

[Product Manager CNC Software]

Jack2ME: I just created a few samples with different machines and all verified properly for me. Can you please send in file to [email protected] so we can take a look.

[JACK2ME]

Jack2ME: I just created a few samples with different machines and all verified properly for me. Can you please send in file to [email protected] so we can take a look.

Kenneth,

 

I have sent a zip2go file to the above mentioned email. Thank you.

[Product Manager CNC Software]

JACK2ME, We have received it and are looking into it. Looks like a legit bug to me on initial view. Thanks for sending it in.

[JACK2ME]

JACK2ME, We have received it and are looking into it. Looks like a legit bug to me on initial view. Thanks for sending it in.

 

Thanks for looking at it Kenneth.

[JACK2ME]

JACK2ME, We have received it and are looking into it. Looks like a legit bug to me on initial view. Thanks for sending it in.

 

Kenneth, I was hoping that MU2 might fix the above mentioned issue but it hasn't. When can I expect a fix for this? This is very disappointing being that it was brought to CNC's attention back in December.

[Product Manager CNC Software]

Hi Jack, We have this issue fixed in our daily builds. It did not make the MU2 release because we didn't fix it quickly enough to make the cutoff date for MU. It was bit more involved than we had anticipated which caused the delay. You can see a version with this fix in it, when X8 goes into public beta which is on schedule for the first half of May. This was fixed under issue D-08857.

[JACK2ME]

Hi Jack, We have this issue fixed in our daily builds. It did not make the MU2 release because we didn't fix it quickly enough to make the cutoff date for MU. It was bit more involved than we had anticipated which caused the delay. You can see a version with this fix in it, when X8 goes into public beta which is on schedule for the first half of May. This was fixed under issue D-08857.

 

Ok thanks Kenneth.