Change mouse spin settings

[Hertz]

Hi guys, just wondering how to change my mouse spin settings. When I grab a model, its not spinning or turning in the direction I'm used to. Its almost as if its reversed. Are there settings somewhere to adjust? It works fine in Solidworks. Just Mastercam is different.

 

Using X6 MU3

[LA CAMmer]

Go to Settings >> Configuration >> Screen >> and check "Reverse Mouse Wheel"

[K2csq7]

That is for rolling the mouse wheel for zoom.

I don't think there is a way to reverse the spin.

 

The only thing I know about is the "enable free mode in dynamic spin" (On the same branch of the sys config)

[Hertz]

No its not the actual wheel. Its when I hold the middle mouse button down and then spin the part. Reversing mouse wheel did nothing.

 

 

EDIT. I found it. I had to turn on "use free mode in dynamic spin"

 

Thanks though for leading me to the proper settings page

 

 

Just noticed your post K2, lol Thank you as well.