X8 Model Prep push pull

[MadPickinSkills]

I'm trying to use the new Model Prep functionality, specifically Push-Pull. I'm unable to "grab" the arrow and drag it to resize (or reposition) walls and fillets. Am I missing something? 

trying to do things like in this video 

Thanks

[CJep]

Are you getting a warning in the upper right of the graphics background?

I had a part recently that would allow movement in one direction only, it was due to two drilled holes that partially broke through three of the faces that would be affected by the move. I had to remove the holes first using the remove feature, move the floor to the new height then I put the holes back by extrude cutting.  

[MadPickinSkills]

Are you getting a warning in the upper right of the graphics background?

I had a part recently that would allow movement in one direction only, it was due to two drilled holes that partially broke through three of the faces that would be affected by the move. I had to remove the holes first using the remove feature, move the floor to the new height then I put the holes back by extrude cutting.  

Thanks for the response. No, there is no warning message. I've seen it before but not for this. Specifically, I'm trying to dynamically change the size of an internal fillet. I select the fillet, press enter, then hover my mouse over the arrow but I'm not able to grab it.

[Guest MTB Technical Services]

The one thing that I found a bit disappointing about the model prep tools is that there is no UnDo.

 

Still, it's definitely a step in the right direction.

[Newbeeee™]

The one thing that I found a bit disappointing about the model prep tools is that there is no UnDo.

 

Still, it's definitely a step in the right direction.

Or the wrong direction if you pull instead of push...

[peon]

^{Mad, you are zoomed too close.  You must zoom out and then grab the handle.}

[Rstewart]

The one thing that I found a bit disappointing about the model prep tools is that there is no UnDo.

 

Still, it's definitely a step in the right direction.

I always hit Save before I try something, so I can exit w/o saving if the part gets all jacked up.

[Zoober]

^{Mad, you are zoomed too close. You must zoom out and then grab the handle.}

I find if I do Gview=Tplane (on my RMB), no matter the zoom level, I can get the handle.

[crazy^millman]

I have not had any problems with it. I do forget to grab the arrow from time to time, but other than that it has been rock solid for me. I am using it on my collet models and soft jaws models to adjust sizes without needing to use wireframe anymore. Be cool if it showed diameter and not radius on round features.

 

HTH

[MadPickinSkills]

^{Mad, you are zoomed too close.  You must zoom out and then grab the handle.}

Yup, thats the answer. Thanks